"Shoot
& Tune, that is how we make Rifles Shoot. Our shooting bench
is only 10 steps from the Work Bench!! We can test our work out
to 1,000 yds." - Chief AJ
Here's our work bench inside the White Barn with .30 Carbine in
progress. Today we are going to work on a used MINI 14 that we
got from a pawn shop. We agree with Col. Cooper that you should
know how your rifle is hitting at 200yds and this mini was a
9" 3 shot spread at 200. This MINI 14 needs our full works.
Back 10 steps to the Work bench inside the White Barn and
disassemble the MINI. Redo the Metal bedding, rebuild the gas
diversion system, clean and lube the op rod. Clean and grease
the rails. With special polishing products from Pro-Shot with
hand lap and polish the inside for the Bore for over 30 minutes.
Do a trigger job with over travel stop to end the rearward
movement of the trigger as soon as the hammer is tripped.
Trigger was 11 pound pull before and we worked this one down to
3 pounds. Installed our in house Chief AJ compensatory of the
"BOSS" type which harmonically controls barrel whip.
Redo the top gas block with our Scout Mount to get the line of
sight inline with the flight of the bullet. All of these
protocols came about after 10 years of working on the MINI 14
& 30
It was a half of a working day later when we got back to the
shooting bench and the 200 yd. armor plate life size Coyote.
Wow, 3 shot right where they should be. A spread of 2 1/2"
which means that a bullet hits the 200 yard target only 1
1/4" from where the cross-hairs were when the rifle went
off. As you can see this was not a nice warm summer day, but
winter, snow, 5-8 mph wind and 28. Before Velocity = 3,050 fps
After Velocity = 3,220 a gain of 170 fps!!!!
Did shoot a 100 yd. group both before and after Tune Job. Before
was 1 3/4" and after on our new Scout Rifle target a small
outstanding 3 shot 5/8" group. This was the Deluxe all the
way Scour Rifle conversion which cost $500.00 Which does include
a new Leopold Scout Scope, comp. and forward mount.
DELUXE TUNE JOB & CONVERSION TO SCOUT 14 $500.00
Take a look Scout Rifle
Tune job only on your MINI 14 or 30: $85.00
Compensator w/ tune add 30.00
Yes, you can order just the Scout Mount: Forward Scout Mount (see-thru)
$ 65.00
Trigger job w/stop, send only your trigger group 55.00
Chief AJ, USMC Trained in Rifles. Talk to the Chief about rifles
at: (217) 253-2959
Chief AJ rifles are listed in the "BLUE BOOK of GUN VALUES"
so this CHIEF AJ LOGO is etched into each customers rifle worked
on here at the White Barn. This LOGO proves that your rifle has
been to the White Barn and gives your rifle add value.
You can order our fine Rifle Products by phone, FAX
1-217-834-3398
1-217-253-2959 Phone: Snail Mail Chief AJ, POB 131,Tuscola,
IL 61953.
|
